Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward hug bearings
   9.5. Forward lower frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross stability of a forward suspension bracket
   9.8. Lower lever of a forward suspension bracket
   9.9. Replacement of the lower hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Lower lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of steering
   9.21. Removal of air from system of steering with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Angles of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

9.4. Replacement of forward hug bearings

PERFORMANCE ORDER
1. Remove a rotary fist.
2. For removal of a nave from a rotary fist use a press and a tubular mandrel of the corresponding diameter.
3. Establish a rotary fist by inside up and, using a metal mandrel, choose a nave from hug bearings.
4. Using a stripper, remove an internal ring of the bearing from a nave.
5. Remove a lock ring of fastening of the bearing from the inside of a rotary fist.
6. If necessary establish an internal ring of the bearing back and, opiry an internal part of a rotary fist on supports and using a tubular mandrel, squeeze out the bearing from a rotary fist.
7. Clear a nave and a rotary fist of dirt, and lubricant.
8. Reliably fix a rotary fist on supports and install on it the bearing. You make installation of the bearing with use of a tubular mandrel which has to press on an external ring of the bearing.
9. Fix the bearing a new lock ring which has to be established in flutes in a rotary fist.
10. Press a nave in the bearing. At the same time use a tubular mandrel which presses on an internal ring of the bearing.
11. Install a rotary fist together with a nave on the car.