Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward hug bearings
   9.5. Forward lower frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross stability of a forward suspension bracket
   9.8. Lower lever of a forward suspension bracket
   9.9. Replacement of the lower hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Lower lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of steering
   9.21. Removal of air from system of steering with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Angles of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

9.16. Steering column

Removal

PERFORMANCE ORDER
1. Remove a steering wheel.
2. Remove casings of a steering column for what unscrew an inclined control lever.
3. Unscrew two screws from a forward part of a casing.
4. Unscrew three screws from the lower part of a casing.
5. Remove the top casing of a steering column.
6. Remove the lower casing of a steering column.
7. Remove the index of provisions of a key in the ignition lock.
8. Remove switches of turns and screen wipers.
9. Remove the ignition lock.
10. Remove the lower finishing of the dashboard from the driver, then remove the air channel connecting the air distributor to a heater.
11. In a niche for legs of the driver unscrew screws and remove finishing of salon for access to a bracket of support of a steering column. Unscrew the lower bolt and the top nuts and remove a support bracket.
12. Note the provision of an intermediate shaft of rather steering column. Unscrew tightening a bolt and remove an intermediate shaft from grooves on the lower part of a steering shaft.
13. Unscrew bolts of the top fastening of a steering column and take a steering column from the car.

Installation

PERFORMANCE ORDER
1. Establish a steering column and half screw in bolts of fastening of a steering column.
2. Check correctness of installation of a steering column and finally tighten fastening bolts.
3. Establish an intermediate shaft on vents of the basis of a steering shaft. Apply the means interfering unscrewing on a carving of a tightening bolt, and screw up tightening a bolt.
4. Establish a bracket of support of a steering column and freely screw nuts. Apply the means interfering unscrewing on a carving of a bolt, and fix by a bolt a bracket of support of a steering column. Finally tighten nuts of fastening of a bracket of support of a steering column.
5. Establish into place an air duct and finishing of salon in a niche for the driver's legs.
6. Put the ignition lock.
7. Install switches of turns and screen wipers.
8. Establish casings of a steering column.
9. Establish a steering wheel.