Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. Running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward hug bearings
   9.5. Forward lower frame
   9.6. The lobby is resistant
   9.7. Stabilizer of cross stability of a forward suspension bracket
   9.8. Lower lever of a forward suspension bracket
   9.9. Replacement of the lower hinge of a forward suspension bracket
   9.10. Back nave
   9.11. Back rack
   9.12. Stabilizer of cross stability of a back suspension bracket
   9.13. Top lever of a back suspension bracket
   9.14. Lower lever of a back suspension bracket
   9.15. Steering wheel
   9.16. Steering column
   9.17. Intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. Pump of the amplifier of steering
   9.21. Removal of air from system of steering with the amplifier
   9.22. Tip of steering draft
   9.23. Steering draft
   9.24. Angles of installation of wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


9.23. Steering draft


1. Remove steering transfer.
2. Remove the corresponding tip of steering draft.
3. Measure distance from a lock-nut of a tip of steering draft until the end of steering draft, then unscrew a lock-nut.
4. Weaken collars and remove a protective cover of steering transfer.
5. Unscrew the internal spherical hinge of steering draft from a gear lath and remove steering draft.


1. Screw up the spherical hinge in a gear lath the required moment.
2. Establish a protective cover of the steering mechanism on its case and steering draft and fix it by collars.
3. Screw a lock-nut in situation in which it was before removal.
4. Establish a tip of steering draft.
5. Establish steering transfer.
6. Check and, if necessary, adjust the angles of installation of forward wheels.