|
Opel Vectra Bsince 1995 releaseRepair and operation of the car |
|
Vektr's Opel of B + 1.1. Governing bodies and control devices + 2. Maintenance + 3. Engines + 4. Heating, ventilation + 5. Fuel system + 6. Systems of start, ignition + 7. Transmission + 8. Brake system - 9. Running gear 9.1. Introduction 9.2. Technical characteristics 9.3. Rotary fists 9.4. Replacement of forward hug bearings 9.5. Forward lower frame 9.6. The lobby is resistant 9.7. Stabilizer of cross stability of a forward suspension bracket 9.8. Lower lever of a forward suspension bracket 9.9. Replacement of the lower hinge of a forward suspension bracket 9.10. Back nave 9.11. Back rack 9.12. Stabilizer of cross stability of a back suspension bracket 9.13. Top lever of a back suspension bracket 9.14. Lower lever of a back suspension bracket 9.15. Steering wheel 9.16. Steering column 9.17. Intermediate shaft of a steering column 9.18. Replacement of protective covers of steering transfer 9.19. Steering transfer + 9.20. Pump of the amplifier of steering 9.21. Removal of air from system of steering with the amplifier 9.22. Tip of steering draft 9.23. Steering draft 9.24. Angles of installation of wheels + 10. Body + 11. Electric equipment + 12. Main malfunctions |
9.24. Angles of installation of wheels
Angles of installation of wheels The angles of installation of wheels considerably influence stability of the car, wear of tires and fuel consumption. Distinguish the following angles of installation of wheels: Disorder is an inclination of a wheel in the vertical plane of rather average line of the car. It can be positive if wheels are inclined outside or negative if wheels are inclined inside. The disorder corner, generally influences uniformity of wear of tires of forward wheels. If disorder of one wheel positive, and another negative, then takes away the car aside at the movement on a straight line. Convergence – side distance between wheels. The positive convergence means that wheels are in front located more closely to each other, than behind at measurement at height of an average point of a wheel. The negative convergence means that wheels in front are at bigger distance from each other, than behind. The cross inclination of an axis of turn of a wheel is a corner between the axis of an inclination of a rotary fist and a vertical which is carried out through a point of fastening of a wheel, looking in the longitudinal direction of the car. At the expense of corners of disorder and a cross inclination of an axis of turn of a point of a contact of wheels with the road settle down closer to an axis of a rotary fist. It supports a so-called "shoulder of a running in". The "running in shoulder" is less, the driving is easier. Also blows from roughness of a covering are less transferred to steering. Corner of a longitudinal inclination of an axis of turn. The axis concerning which there is a turn of a wheel is placed in space so that its lower part is inclined forward. Such corner of a longitudinal inclination is called positive. At positive value of a corner self-return of a wheel to average situation after turn improves. Check and adjustment of angles of installation of wheels need to be made at the station in connection with complexity of the used equipment. |
|