Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
- 11. Electric equipment
   - 11.1. Electric equipment
      11.1.1. Introduction
      11.1.2. Technical characteristics
      11.1.3. Electric chains
      11.1.4. Detection of not closed chain
      11.1.5. Safety locks and relay
      11.1.6. Switches
      11.1.7. Bulbs of external lighting
      11.1.8. Bulbs of internal lighting
      11.1.9. Devices of external lighting
      11.1.10. Adjustment of light of headlights
      11.1.11. Combination of devices
      11.1.12. Screen wiper levers
      11.1.13. Engine of a screen wiper and draft
      11.1.14. Engine of a screen wiper of a back door
      11.1.15. Windscreen washer
      11.1.16. Radio tape recorder
      11.1.17. Loudspeakers
      11.1.18. Safety cushion
      11.1.19. Safety cushion elements
   + 11.2. Electrical circuitries
+ 12. Main malfunctions


I found a website for buying a selling business and I think I might buy a snap on routes for sale here
d65d3f49

11. Electric equipment

11.1. Electric equipment

11.1.1. Introduction

GENERAL INFORMATION

Consumers unite to the plus power supply a wire, and with minus - through a car body (weight). Such method allows to reduce number of wires and to simplify installation. On cars the low-served or unattended accumulators are installed.

The electric system has 12-tivoltovy food with negative grounding and the generator, a starter, consumers of the electric power and electric chains consists of the accumulator.

Accumulator charging is made from the generator which is put in action by a belt from a pulley of a bent shaft. The starter represents the electric motor of a direct current with the mixed excitement with the electromagnetic traction relay. At start the traction relay moves the leading gear wheel to gearing with a gear wreath of a flywheel before the starter receives a power supply from the accumulator. After start of the engine the coupling of a free wheeling disconnects a starter anchor from a gear wreath of a flywheel.

Precautions

When working on electric system it is necessary to be careful not to damage the semiconductor device (diodes and transistors). During the work on electric system it is necessary to fulfill the following requirements:

 – in operating time of the engine do not disconnect the accumulator, the generator of alternating current or any electric sockets;
 – when carrying out any works remove the negative plug from the accumulator;
 – when carrying out electrowelding works on the car, switch-off the generator of alternating current and the control device.