Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   - 3.1. Repair of the SOCH engine installed in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.1.5. Cover of a head of the block of cylinders
      3.1.6. Pulley of a bent shaft
      3.1.7. Casings of a gear belt
      3.1.8. Gear belt
      3.1.9. Mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. Cam-shaft and cases of a cam-shaft
      3.1.12. Hydraulic pushers
      3.1.13. Head of the block of cylinders
      3.1.14. Oil pallet
      3.1.15. Oil pump
      3.1.16. Drive flywheel / plate
      3.1.17. Replacement of sealing rings of a bent shaft
      3.1.18. Suspension bracket of the power unit
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   + 3.4. Repair of the diesel engine of 2,0 l installed in the car
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

3.1.17. Replacement of sealing rings of a bent shaft

Right sealing ring

PERFORMANCE ORDER

1. Remove a pulley of a bent shaft.
2. Drill two small openings located in the opposite ends of a sealing ring in a sealing ring.
	3. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
4. Clear a nest for a sealing ring.
	5. Oil pure engine working edges of a new sealing ring and establish it on a bent shaft.
6. Remove all traces of engine oil and establish a pulley of a bent shaft.

Left oil sealing ring of a bent shaft

PERFORMANCE ORDER

1. Remove a flywheel. Measure depth of installation of a sealing ring in a nest.

2. Drill two small openings located in the opposite ends of a sealing ring in a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.

3. Clear a nest for a sealing ring.

4. Oil pure engine working edges of a new sealing ring and establish it into place.

5. Remove all traces of engine oil and establish a flywheel.