Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   - 3.1. Repair of the SOCH engine installed in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.1.5. Cover of a head of the block of cylinders
      3.1.6. Pulley of a bent shaft
      3.1.7. Casings of a gear belt
      3.1.8. Gear belt
      3.1.9. Mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. Cam-shaft and cases of a cam-shaft
      3.1.12. Hydraulic pushers
      3.1.13. Head of the block of cylinders
      3.1.14. Oil pallet
      3.1.15. Oil pump
      3.1.16. Drive flywheel / plate
      3.1.17. Replacement of sealing rings of a bent shaft
      3.1.18. Suspension bracket of the power unit
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   + 3.4. Repair of the diesel engine of 2,0 l installed in the car
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

3.1.12. Hydraulic pushers

Removal

PERFORMANCE ORDER
1. Remove the camshaft case.
2. Remove levers of a block of axial pressure.
3. Remove a block of axial pressure.
4. Remove hydraulic pushers and place everything in the corresponding container so that at installation they became everyone on the place.

Check

PERFORMANCE ORDER
1. Check the working surfaces of the bearing, a pusher, the valve which work in contact with camshaft cams.
2. If hydraulic pushers defective, them it is necessary to replace as their check is impossible.

Installation
PERFORMANCE ORDER
1. Grease hydraulic pushers and nests in a head of the block of cylinders with pure engine oil. Establish hydraulic pushers on the places.
2. Establish blocks of axial pressure upon the top parts of the corresponding valves.
3. Oil levers pure engine and install them on the places. Then install the camshaft case.