Vektr's Opel of B + 1.1. Governing bodies and control devices + 2. Maintenance - 3. Engines + 3.1. Repair of the SOCH engine installed in the car + 3.2. Repair of the DOCH engine installed in the car + 3.3. Repair of the diesel engine of 1,7 l installed in the car - 3.4. Repair of the diesel engine of 2,0 l installed in the car 3.4.1. Introduction 3.4.2. Technical characteristics 3.4.3. Check of pressure of compression 3.4.4. Top Dead Point (TDP) of the piston of the first cylinder 3.4.5. Check and adjustment of the mechanism of gas distribution 3.4.6. Cover of a head of the block of cylinders 3.4.7. Pulley of a bent shaft 3.4.8. Chain cover 3.4.9. Natyazhiteli of a chain 3.4.10. Chains and asterisks 3.4.11. Camshafts and pushers 3.4.12. Head of the block of cylinders 3.4.13. Oil pallet 3.4.14. Oil pump 3.4.15. Oil heater 3.4.16. Replacement of sealing rings of a bent shaft 3.4.17. Flywheel 3.4.18. Suspension brackets of the power unit + 3.5. Capital repairs of engines + 4. Heating, ventilation + 5. Fuel system + 6. Systems of start, ignition + 7. Transmission + 8. Brake system + 9. Running gear + 10. Body + 11. Electric equipment + 12. Main malfunctions
|
Removal
PERFORMANCE ORDER |
1. Lift a forward part of the car and record on supports. Remove the right wheel. |
2. Take off an auxiliary driving belt. |
3. Weaken a bolt of fastening of a pulley of a bent shaft. For an exception of a provorachivaniye of a bent shaft record it, having included any transfer and having pressed a brake. |
4. Unscrew a bolt and remove a pulley of a bent shaft. Check a condition of an oil sealing ring of a bent shaft and, if necessary, replace it. |
|
Installation
Prevention
At installation of a pulley it is necessary to use a new bolt.
PERFORMANCE ORDER |
|
1. Establish a pulley on a bent shaft. At the same time combine a groove in a pulley with a spline of a bent shaft. |
|
2. Establish a bolt of fastening of a pulley of a bent shaft. |
|
3. Record a bent shaft from a provorachivaniye and in stages tighten a bolt of fastening of a pulley of a bent shaft. |
4. Establish an auxiliary driving belt. |
5. Establish a wheel and lower the car. |
|
|
|