Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine installed in the car
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   - 3.4. Repair of the diesel engine of 2,0 l installed in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.4.5. Check and adjustment of the mechanism of gas distribution
      3.4.6. Cover of a head of the block of cylinders
      3.4.7. Pulley of a bent shaft
      3.4.8. Chain cover
      3.4.9. Natyazhiteli of a chain
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. Head of the block of cylinders
      3.4.13. Oil pallet
      3.4.14. Oil pump
      3.4.15. Oil heater
      3.4.16. Replacement of sealing rings of a bent shaft
      3.4.17. Flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

Dive into endless entertainment possibilities and discover your next favorite title on 123Movies.

3.4.13. Oil pallet

Removal

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.
2. Lift a forward part of the car and record on supports.
3. Merge engine oil. Establish a new washer on a masloslivny stopper and install a stopper in the oil pallet, having tightened it the required moment.
	4. Disconnect electric sockets from sensors of temperature and level of oil.
	5. Unscrew bolts of fastening of a ledge of the oil pallet to a transmission case.
6. Gradually and consistently unscrew bolts of fastening of the oil pallet to the block of cylinders. Remove the oil pallet and laying.
	7. Unscrew bolts of fastening of a pipe of an oil receiver and check a condition of the mesh filter.

Installation

PERFORMANCE ORDER

1. Clear all traces of oil and dirt from the interfaced surfaces of the pallet and block of cylinders.
2. Establish a new sealing ring on a pipe of an oil receiver and establish a pipe into place.

3. Apply a thin film of sealant on the lower surface of the block of cylinders interfaced to the oil pump and a back main cover of the bearing (places of putting sealant are specified by shooters).
	4. Install laying on the oil pallet and install laying on the block of cylinders. Fix the oil pallet by bolts.
5. Working from the center in the diagonal sequence, tighten bolts of fastening of the oil pallet.
6. Screw up bolts of fastening of a ledge of the oil pallet to a transmission case.
7. Connect electric sockets to sensors of temperature and level of oil.
8. Lower the car and fill in engine oil in the engine.