Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine installed in the car
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   - 3.4. Repair of the diesel engine of 2,0 l installed in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.4.5. Check and adjustment of the mechanism of gas distribution
      3.4.6. Cover of a head of the block of cylinders
      3.4.7. Pulley of a bent shaft
      3.4.8. Chain cover
      3.4.9. Natyazhiteli of a chain
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. Head of the block of cylinders
      3.4.13. Oil pallet
      3.4.14. Oil pump
      3.4.15. Oil heater
      3.4.16. Replacement of sealing rings of a bent shaft
      3.4.17. Flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions



3.4.16. Replacement of sealing rings of a bent shaft

PERFORMANCE ORDER
Right sealing ring of a bent shaft
1. Remove a pulley of a bent shaft.
2. Using a screw-driver edge as the lever, take a sealing ring from a chain cover.
3. Clear a nest of a sealing ring and the condensed surface of a bent shaft.
4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring.
5. Remove all traces of oil and establish a pulley of a bent shaft.
Left sealing ring of a bent shaft
6. Remove a flywheel.
7. Drill two small openings in an end face of a sealing ring, screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
8. Clear a nest of a sealing ring and the condensed surface of a bent shaft.
9. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring into place.
10. Establish a flywheel.