Vektr's Opel of B + 1.1. Governing bodies and control devices + 2. Maintenance - 3. Engines + 3.1. Repair of the SOCH engine installed in the car - 3.2. Repair of the DOCH engine installed in the car 3.2.1. Introduction 3.2.2. Technical characteristics 3.2.3. Check of a compression 3.2.4. Top Dead Point (TDP) of the piston of the first cylinder 3.2.5. Cover of a head of the block of cylinders 3.2.6. Pulley of a bent shaft 3.2.7. Casings of a gear belt 3.2.8. Gear belt 3.2.9. Pulleys of a gear belt, mechanism of a tension and single pulley 3.2.10. Replacement of oil sealing rings of a cam-shaft 3.2.11. Cam-shaft and pushers 3.2.12. Head of the block of cylinders 3.2.13. Oil pallet 3.2.14. Oil pump 3.2.15. Drive flywheel / plate 3.2.16. Replacement of oil sealing rings of a bent shaft 3.2.17. Suspension bracket of the power unit + 3.3. Repair of the diesel engine of 1,7 l installed in the car + 3.4. Repair of the diesel engine of 2,0 l installed in the car + 3.5. Capital repairs of engines + 4. Heating, ventilation + 5. Fuel system + 6. Systems of start, ignition + 7. Transmission + 8. Brake system + 9. Running gear + 10. Body + 11. Electric equipment + 12. Main malfunctions
|
Removal
PERFORMANCE ORDER |
Prevention
For fastening of a pulley it is necessary to use a new bolt.
|
1. Lift a forward part of the car and record on supports. Remove the right wheel. |
2. Take off an auxiliary driving belt. |
3. Weaken a bolt of fastening of a pulley of a bent shaft. It is necessary for prevention of a provorachivaniye of a bent shaft that the assistant included any transfer and pressed a brake. On models with the automatic transmission unscrew one of bolts of fastening of the hydrotransformer and, using the steel core inserted through an opening under a bolt block a drive plate. |
Engines of 1,6 l |
4. Unscrew a bolt of fastening of a pulley and remove a pulley from a bent shaft. |
L engines 1,8 and 2,0 |
5. For a bolt of fastening of a pulley of a bent shaft turn a bent shaft until the tag on a pulley is not combined with the index on a cover. |
6. Unscrew bolts of fastening of an auxiliary pulley to a pulley of a gear belt and remove a pulley. |
|
Installation
PERFORMANCE ORDER |
Engines of 1,6 l |
1. Establish a pulley of a bent shaft. At the same time combine a groove on a pulley with a ledge on a pulley of a gear belt. |
2. Fix a pulley by a bolt. At the same time record a bent shaft from a provorachivaniye. |
3. Establish an auxiliary driving belt. |
4. Establish a wheel and lower the car. |
L engines 1,8 and 2,0 |
5. Check that the tag of a pulley of a bent shaft is combined with a tag on the case, and establish a pulley of an auxiliary maple belt on a bent shaft. Combine a tag on a pulley with the index and fix a pulley by bolts. |
6. Establish an auxiliary driving belt. |
7. Establish a wheel and lower the car. |
|
|
|