Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
- 1.1. Governing bodies and control devices
   1.2. Combination of devices
   1.3. Control bulbs
   1.4. The counter of the passable way and hours
   1.5. Triple - Info - the display
   1.6. Multi - Info - the display
   1.7. Multi - Info - the display - Check-control
   1.8. Multi - Info - the display - the On-board computer
   1.9. System of heating and ventilation
   1.10. Conditioner
   1.11. Heating
   1.12. Electronic climate control
   1.13. TC system
   1.14. Cruise control
   1.15. Catalyst
   1.16. Signaling device of electronic system of the engine
   1.17. System of production of the fulfilled gases
   1.18. Automatic transmission
   1.19. Instructions on driving
   1.20. Fuel economy
   1.21. Fuel grade
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

1.5. Triple - Info - the display

GENERAL INFORMATION

Indication of time, external temperature, and also radio receiver or date.

At the included ignition time and external temperature are displayed, at the switched-off radio receiver date is displayed.
Brightness of indication is regulated at the included lighting by means of the right regulator located under the lighting switch.
At the switched-off ignition indication of time, date and external temperature by short pressing of one of two buttons from above of the display can be caused short-term, about 15 sec.

Installation of date and time

 

To switch off the radio receiver, and to press the buttons over the display in the following order:

Installation mode:

about 2 sec., days blink;
to establish day;
months blink;
to establish month;
years blink;
to establish year;
hours blink;
to establish hours;
minutes blink;
to establish minutes;
hours to within a second join.

If time needs installation only, then in the mode of installation to press the button until hours or minutes begin to blink.

Automatic installation of date and time

Automatic installation of date and time is possible during reception of broadcasts from radio stations with RDS of RDS radiating a signal.
Automatic installation is carried out after turning on of the radio receiver and reception of a signal of RDS. Process of installation is displayed on the display by means of. If there is no reception of a signal of RDS or it low-quality, then date and time should be determined manually.
Switching off and inclusion of automatic installation (e.g. during low-quality reception of a signal of RDS from radio station):

to hold pressed about 2 seconds, clock is put in the installation mode;
to press two times (years will not start blinking yet);
to hold pressed about 3 seconds, will not start blinking on the display yet and not to appear the inscription "RDS TIME" (during it years blink);
to press, indication on the display:
RDS TIME 0 = off,
RDS TIME 1 = incl.;
to press three times.

External temperature

The going-down temperature is displayed immediately, raising – with a delay.
For the warning of frosting of the road indication at a temperature below 3 °C on the display is removed a symbol.