Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
- 10. Body
   10.1. Introduction
   10.2. Care of a body
   10.3. Care of an upholstery and rugs
   10.4. Repair of insignificant damages of a body
   10.5. Repair of strong damages of a body
   10.6. Front bumper
   10.7. Rear bumper
   10.8. Front grille
   10.9. Cowl
   10:10. Cowl racks
   10:11. Cowl lock cable
   10:12. Doors
   + 10:13. Door upholstery
   10:14. Internal handle of a door
   10:15. External handle of opening of a forward door
   10:16. External handle of opening of a back door
   10:17. Lock of a forward door
   10:18. Lock of a back door
   10:19. Door window regulator
   10:20. Door glass
   10:21. Trunk lid
   10:22. Trunk lid lock
   10:23. Trunk lid lock cylinder
   - 10:24. Back door
      10.24.1. Back door of the Hatchback models
      10.24.2. Back door of the Station wagon models
   10:25. Racks of a back door
   10:26. Lock of a back door
   10:27. Cylinder of the lock of a back door
   + 10:28. System of the central blocking
   + 10:29. Power windows
   + 10:30. External rear-view mirrors
   10:31. Front seat
   10:32. Pillow of a back seat
   10:33. Back of a back seat
   10:34. Seat belt of a front seat
   10:35. Lock of a forward seat belt and mechanism of a tension
   10:36. Seat belt of a back seat and drum
   10:37. Central console
   10:38. Dashboard
+ 11. Electric equipment
+ 12. Main malfunctions


10.24.2. Back door of the Station wagon models


1. Remove a weight wire from the accumulator.
2. Open a back door and unscrew screws, release fastening brackets.
3. Remove an upholstery of a back door.
4. Disconnect the electric socket located under glass of a back door.
5. Unscrew a bolt and disconnect the tire of grounding of a back door.
6. Disconnect electric sockets from a heater of back glass, the switch of illumination of salon, a lamp of illumination of registration plate, the engine of a steloochistitel, the engine of the central blocking of a door and the switch of anticreeping system.
7. Tie a thin cord to the end of a plait of wires, then take a plait of wires from the top part of a back door. Untie a cord and leave it at doors.
8. Disconnect a hose of a washer of glass of a back door.
9. Holding a back door in open situation, disconnect racks of support of a back door.
10. Take brackets of fixing of pins of the hinge (shooter) and a drift beat out pins and remove a back door.


1. Installation is made in the sequence, the return to removal. Check that the lock of a back door is accurately fixed on a shock plate.
2. If adjustment of provision of a shock plate is necessary, unscrew screws of fastening of finishing of the lower part of a doorway, weaken bolts of fastening of a shock plate, adjust its situation and again fix by bolts.