Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
+ 7.1. Coupling
+ 7.2. Mechanical transmission
- 7.3. Automatic transmission
7.3.1. Introduction
7.3.2. Technical characteristics
7.3.3. Replacement of oil in the transmission
7.3.4. Adjustment of the lever of the selector
7.3.5. Selector cable
7.3.6. Selector lever
7.3.7. Replacement of a sealing ring of the hydrotransformer
7.3.8. Electric elements of control of the transmission
7.3.9. Switch of a manner of the movement
7.3.10. Electronic control device
7.3.11. Sensors of the entrance and conducted transmission shaft
7.3.12. Transmission oil temperature sensor
7.3.13. Removal and installation of the transmission
7.3.14. Capital repairs of the transmission
+ 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions
|
Lock of a starter and switch of lamps of a backing
|
|
1. Marking
2. Bolt
3. Shaft of the mechanism of the choice of transfers
4. Bolt |
Lock of a starter and switch of a lamp of a backing
The lock of a starter and the switch of lamps of a backing includes backing lamps at installation of the mechanism of the choice of transfers to the relevant provision and prevents start of the engine when any transfer is included.
Removal
| PERFORMANCE ORDER |
| 1. Install the selector lever in situation N. |
| 2. For access to the switch remove the accumulator and a support of the accumulator. |
| 3. Remove a selector cable from the lever of the choice of transfers on the transmission. Unscrew a nut and remove the lever from a shaft of the mechanism of the choice of transfers. |
| 4. Disconnect the electric socket of the switch located on wires. |
| 5. On the engine 1,8 and 2,0 of l take the probe for measurement of level of oil in the transmission, unscrew a nut and remove a probe pipe. |
| 6. Unscrew a nut from a shaft of the choice of transfers. |
| 7. Unscrew a bolt of fastening of a plate of the switch and take the switch from a motor compartment. |
| 8. Installation is made in the sequence, the return to removal. At the same time it is necessary to make adjustment of the switch. |
|
Adjustment
Prevention
Before adjustment of the switch check that the cable of the selector is correctly adjusted.
| PERFORMANCE ORDER |
| 1. Install the selector lever in situation N. |
| 2. For access to the switch remove the accumulator and a support of the accumulator. |
| 3. Remove a selector cable from the lever of the choice of transfers on the transmission. Unscrew a nut and remove the lever from a shaft of the mechanism of the choice of transfers. |
| 4. On the transmission installed in neutral situation, washers on a shaft of the mechanism of the choice of transfers have to be parallel to marking on the switch case (see rice. Lock of a starter and switch of lamps of a backing). If it is necessary to make adjustment, weaken bolts of fastening of the case of the switch and turn the switch in required position. |
| 5. Install the lever of the choice of transfers and fix by a nut. Connect a selector cable to the lever and fix by a bracket. |
| 6. Install the accumulator and check operation of the switch. |
|
|
|
