Vektr's Opel of B + 1.1. Governing bodies and control devices + 2. Maintenance + 3. Engines + 4. Heating, ventilation + 5. Fuel system + 6. Systems of start, ignition - 7. Transmission + 7.1. Coupling + 7.2. Mechanical transmission - 7.3. Automatic transmission 7.3.1. Introduction 7.3.2. Technical characteristics 7.3.3. Replacement of oil in the transmission 7.3.4. Adjustment of the lever of the selector 7.3.5. Selector cable 7.3.6. Selector lever 7.3.7. Replacement of a sealing ring of the hydrotransformer 7.3.8. Electric elements of control of the transmission 7.3.9. Switch of a manner of the movement 7.3.10. Electronic control device 7.3.11. Sensors of the entrance and conducted transmission shaft 7.3.12. Transmission oil temperature sensor 7.3.13. Removal and installation of the transmission 7.3.14. Capital repairs of the transmission + 7.4. Power shafts + 8. Brake system + 9. Running gear + 10. Body + 11. Electric equipment + 12. Main malfunctions
|
Arrangement of sensors of speed of an entrance shaft and the conducted shaft
|
Sensors are located in the top part of the transmission. The sensor of speed of an entrance shaft is located closer to the left forward end of the transmission. 1. Sensor of speed of an entrance shaft 2. The sensor of speed of the conducted shaft |
Removal
PERFORMANCE ORDER |
1. For access to sensors remove the accumulator and a support of the accumulator. |
2. Disconnect the electric socket from sensors. |
3. Unscrew bolts and remove sensors. |
|
Installation
PERFORMANCE ORDER |
Installation is made in the sequence, the return to removal. At the same time it is necessary to install new sealing rings on sensors. |
|
|
|