Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Replacement of oil in the transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of control of the transmission
      7.3.9. Switch of a manner of the movement
      7.3.10. Electronic control device
      7.3.11. Sensors of the entrance and conducted transmission shaft
      7.3.12. Transmission oil temperature sensor
      7.3.13. Removal and installation of the transmission
      7.3.14. Capital repairs of the transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


7.3.5. Selector cable

Removal and installation

1. Remove the central console and install the selector lever in situation P.
2. Using an edge of the thin screw-driver (it is specified by an arrow) as the lever, remove a cable of the selector (2) from spherical hinged connection (3) at the selector lever basis. Release a selector cable from a forward part of an arm of the lever of the selector.
1 – fastening bracket.
3. Remove the accumulator and a support of the accumulator.
4. Remove a selector cable from the lever of the choice of transfers on the transmission. Remove a selector cable cover from an arm.
5. Disconnect a selector cable from all brackets of fastening. Take a sealing ring of a cable of the selector from a partition of a motor compartment and take a selector cable.
6. Installation is made in the sequence, the return to removal, at the same time it is necessary to adjust a selector cable.