Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Replacement of oil in the transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of control of the transmission
      7.3.9. Switch of a manner of the movement
      7.3.10. Electronic control device
      7.3.11. Sensors of the entrance and conducted transmission shaft
      7.3.12. Transmission oil temperature sensor
      7.3.13. Removal and installation of the transmission
      7.3.14. Capital repairs of the transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions



7.3.3. Replacement of oil in the transmission

PERFORMANCE ORDER
1. Make a short trip for bringing the transmission to working temperature.
2. Establish the car on the elevator or over a viewing hole.
3. Take the index of level of oil, then install the corresponding container under a drain stopper of the transmission. The drain stopper (1) is located from the back right side of a case of the transmission.
4. Unscrew a drain stopper and merge oil from the transmission.
5. Establish a sealing washer on a stopper and screw up a stopper into place.
6. Fill in oil in the transmission through an oil level measuring instrument pipe.
7. Start the engine in the idling mode for several minutes, switch off the engine and check oil level in the transmission. If necessary add oil. Make control check and repeatedly check oil level.