Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical transmission
   - 7.3. Automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Replacement of oil in the transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. Selector cable
      7.3.6. Selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of control of the transmission
      7.3.9. Switch of a manner of the movement
      7.3.10. Electronic control device
      7.3.11. Sensors of the entrance and conducted transmission shaft
      7.3.12. Transmission oil temperature sensor
      7.3.13. Removal and installation of the transmission
      7.3.14. Capital repairs of the transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


7.3.12. Transmission oil temperature sensor


The sensor of temperature is screwed in in the basis of a forward part of the transmission.


1. Remove a weight wire from the accumulator.
2. Lift a forward part of the car and record on supports.
3. Disconnect the electric socket of the sensor located on wires and exempt conducting of the sensor from fastening brackets.
4. Unscrew bolts (are specified by shooters) and uncover the sensor.
5. Unscrew temperature sensor (it is specified by an arrow) from a transmission case. Quickly close a nest for installation of the sensor of temperature a stopper.


Installation is made in the sequence, the return to removal. At the same time it is necessary to install a new sealing ring on the sensor.