Opel Vectra B

since 1995 release

Repair and operation of the car


Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Pumping of the hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of front brake shoes
   8.6. Replacement of back brake shoes on disk brakes
   8.7. Replacement of back brake shoes on drum brakes
   8.8. Replacement of brake shoes of the emergency brake
   8.9. Lobbies and back brake disks
   8.10. Forward brake disk
   8.11. Back brake disk
   8.12. Back brake drum
   8.13. Forward support
   8.14. Back support
   8.15. Back working brake cylinder
   8.16. Main brake cylinder
   8.17. Brake pedal
   8.18. Vacuum amplifier of brakes
   8.19. Unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of the emergency brake
   8.21. Lever of the emergency brake
   8.22. Cable of the emergency brake
   8.23. Anti-blocking system of brakes (ABS)
   - 8.24. Elements of anti-blocking system of brakes
      8.24.1. Hydraulic modulator and electronic control device
      8.24.2. Sensor of rotation of a wheel
      8.24.3. The vacuum pump of cars with diesel engines
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

8.24.3. The vacuum pump of cars with diesel engines
GENERAL INFORMATION

Arrangement of the vacuum pump on diesel engines of 2,0 l

Arrangement of a nut of fastening of a vacuum hose to the vacuum pump on diesel engines of 2,0 l

Arrangement of the vacuum pump on the generator in diesel engines of 1,7 l

Removal

PERFORMANCE ORDER
1. On diesel engines of 1,7 l the vacuum pump is fixed on the generator of alternating current, and on diesel engines of 2,0 l the pump is attached by bolts to a head of the block of cylinders.
2. On cars with engines of 1,7 l lift a forward part of the car and record on supports.
3. Unscrew a vacuum hose from the vacuum pump.
4. On engines of 1,7 l unscrew a connecting nut and remove a pipe of supply of oil to the pump.

5. Weaken a collar and remove a pipe of return of oil from the vacuum pump.
6. Unscrew bolts and remove the vacuum pump.
7. Remove a sealing ring of the round section (shooter) from the generator on engines of 1,7 l or from a flute in the pump on engines of 2,0 l.

Installation

PERFORMANCE ORDER
Installation is made in the sequence, the return to removal. Before installation of the vacuum pump on the engine of 1,7 l via the union of supply of oil fill in in the oil w cm3 pump 5.

Check

Operability of the vacuum pump of the brake system can check, using the vacuum gage.

PERFORMANCE ORDER
1. Disconnect a vacuum pipe from the pump and instead of it connect the vacuum gage.
2. Start the engine in the idling mode. Measure the vacuum created by the pump. After 1 minute of operation of the engine vacuum has to make about 500 mm Hg. If the vacuum created by the pump does not correspond to the required data, replace the pump completely since spare parts to the pump are not delivered.