Repair and service Vektr's Opel of B - 8.24. Elements of anti-blocking system of brakes//since 1995

Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Pumping of the hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of front brake shoes
   8.6. Replacement of back brake shoes on disk brakes
   8.7. Replacement of back brake shoes on drum brakes
   8.8. Replacement of brake shoes of the emergency brake
   8.9. Lobbies and back brake disks
   8.10. Forward brake disk
   8.11. Back brake disk
   8.12. Back brake drum
   8.13. Forward support
   8.14. Back support
   8.15. Back working brake cylinder
   8.16. Main brake cylinder
   8.17. Brake pedal
   8.18. Vacuum amplifier of brakes
   8.19. Unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of the emergency brake
   8.21. Lever of the emergency brake
   8.22. Cable of the emergency brake
   8.23. Anti-blocking system of brakes (ABS)
   - 8.24. Elements of anti-blocking system of brakes
      8.24.1. Hydraulic modulator and electronic control device
      8.24.2. Sensor of rotation of a wheel
      8.24.3. The vacuum pump of cars with diesel engines
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions



8.24. Elements of anti-blocking system of brakes

8.24.1. Hydraulic modulator and electronic control device

Removal

PERFORMANCE ORDER
1. Remove the accumulator.
2. Remove the relay block from the hydraulic modulator.
3. Uncover a tank of brake fluid and, using the syringe, pump out all liquid from a tank.
4. Disconnect the electric socket from the top part of the hydraulic modulator.
5. Purify dirt of junctions of brake tubes to the main brake cylinder. Enclose rags under places of connections to collect the flowed-out brake fluid. Unscrew nuts of fastening of brake tubes to the main brake cylinder.
6. Unscrew three bolts and remove the hydraulic modulator and the control unit from a motor compartment up.

Installation

PERFORMANCE ORDER

Installation is made in the sequence, the return to removal, but at the same time it is necessary to remove air from the brake system.