Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Pumping of the hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of front brake shoes
   8.6. Replacement of back brake shoes on disk brakes
   8.7. Replacement of back brake shoes on drum brakes
   8.8. Replacement of brake shoes of the emergency brake
   8.9. Lobbies and back brake disks
   8.10. Forward brake disk
   8.11. Back brake disk
   8.12. Back brake drum
   8.13. Forward support
   8.14. Back support
   8.15. Back working brake cylinder
   8.16. Main brake cylinder
   8.17. Brake pedal
   8.18. Vacuum amplifier of brakes
   8.19. Unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of the emergency brake
   8.21. Lever of the emergency brake
   8.22. Cable of the emergency brake
   8.23. Anti-blocking system of brakes (ABS)
   + 8.24. Elements of anti-blocking system of brakes
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

8.22. Cable of the emergency brake

GENERAL INFORMATION

The cable of the emergency brake consists of three sections. The short forward section connects the lever of the emergency brake to the compensator. Secondary left and right sections connect a compensator plate to back brakes. Short a cable connect a back part of the emergency brake to levers on back brake shoes. Each section can be removed separately.

Removal

FORWARD SECTION OF THE CABLE OF THE EMERGENCY BRAKE

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports.
2. In interior of the car remove a protective cover of the emergency brake and remove it on the lever of the emergency brake.
3. Lower the lever of the emergency brake and unscrew an adjusting nut since the forward end of a cable of the emergency brake.
4. Remove a back part of system of production of exhaust gases.
5. Remove the heat-resistant screen for access to a plate of the compensator of the emergency brake.
6. Turn a back part of forward section of the emergency brake on 90 ° and disconnect from a compensator plate.
7. Remove rubber consolidation from the bottom of the car and remove forward section of a cable of the emergency brake.

SECONDARY SECTION OF THE CABLE OF THE EMERGENCY BRAKE

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Completely lower the lever of the emergency brake.
2. Remove a back part of system of production of exhaust gases.
3. Remove the heat-resistant screen for access to a plate of the compensator of a cable of the emergency brake.
4. Move a compensator plate forward, then turn the back end of forward section of a cable of the emergency brake on 90 ° and disconnect a cable from the compensator.
5. Disconnect a back part of each cable from back short cables of the emergency brake.
6. Exempt a cable of the emergency brake from brackets of fastening and take it from under the car.

BACK SECTION OF THE CABLE OF THE EMERGENCY BRAKE

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Completely lower the lever of the emergency brake.
2. Using the screw-driver as the lever, disconnect the clip connecting a secondary and back cable of the emergency brake.
3. Disconnect a cable of the emergency brake from the back lever of brake shoes.

Installation

PERFORMANCE ORDER
Installation is made in the sequence, the return to removal, but at the same time it is necessary to adjust the emergency brake.