Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine installed in the car
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   + 3.4. Repair of the diesel engine of 2,0 l installed in the car
   - 3.5. Capital repairs of engines
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Removal and installation of the petrol engine together with the transmission
      3.5.4. Removal and installation of the diesel engine together with the transmission
      3.5.5. Repair of the engine
      3.5.6. Dismantling of a head of the block of cylinders
      3.5.7. Cleaning and survey of a head of the block of cylinders
      3.5.8. Assembly of a head of the block of cylinders
      3.5.9. Removal of pistons with rods
      3.5.10. Removal of a bent shaft
      3.5.11. Block of cylinders of the engine
      3.5.12. Pistons and rods
      3.5.13. Bent shaft
      3.5.14. Survey of radical and conrod bearings
      3.5.15. Engine balance of assembly at capital repairs
      3.5.16. Installation of piston rings
      3.5.17. Choice of bearings
      3.5.18. Installation of a bent shaft
      3.5.19. Pistons and rods, check of working gaps of conrod bearings
      3.5.20. Check of a working gap of the bearing of the lower head of a rod
      3.5.21. Installation of pistons with rods
      3.5.22. Start of the engine after capital repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions
d65d3f49



3.5.8. Assembly of a head of the block of cylinders

PERFORMANCE ORDER
1. Oil cores of valves engine and insert them on the places. The valve establish on those places where they were ground in.
2. Establish a spring nest.
3. Install the thin-walled protective plug on a valve core.
4. For installation of maslootrazhatelny caps use a special metal mandrel.
5. Establish a valvate spring and a plate of a spring.
6. Special adaptation squeeze a valvate spring and establish crackers in dredging of a core of the valve and grease them. Remove the device for compression of a spring. Repeat this operation on other valves.
7. Knock with the hammer through wooden whetstone on a valve core end face in order that all elements of the valve accurately were established on the places.
8. On the SOCH engine of 1,6 l establish hydraulic pushers, blocks of axial pressure and levers
9. On all petrol DOCH engines install a head on the block of cylinders of the engine and establish pushers and camshafts in a head.
10. On diesel engines of 1,7 l install a head on the block of cylinders of the engine and establish pushers, adjusting laying and the camshaft in a head. Establish fuel nozzles and glow plugs.
11. On diesel engines of 2,0 l install a head on the block of cylinders and establish hydraulic pushers, levers and the camshaft.