Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   - 5.1. Fuel system of petrol engines
      5.1.1. Introduction
      5.1.2. Technical characteristics
      5.1.3. Air filter and inlet channels
      5.1.4. A control system of temperature of the air given to the engine
      5.1.5. Accelerator cable
      5.1.6. Accelerator pedal
      5.1.7. Fuel
      + 5.1.8. System of injection of fuel
      5.1.9. Removal of pressure in fuel system
      5.1.10. Fuel pump
      5.1.11. Fuel level sensor
      5.1.12. Fuel tank
      5.1.13. Throttle case
      5.1.14. Check of system of injection of fuel
      5.1.15. Elements of single-point system of injection of fuel
      + 5.1.16. Elements of multipoint system of injection of fuel
      5.1.17. Inlet collector
      5.1.18. Final collector
      5.1.19. System of production of exhaust gases
   + 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

5.1.5. Accelerator cable

Removal

PERFORMANCE ORDER
1. In a motor compartment remove a bracket of fastening of a cover of a cable of an accelerator and take an accelerator cable from a throttle cam.
2. Release an accelerator cable on all length from under fastening. On models with the automatic transmission it is necessary to disconnect the electric socket from the mechanism of inclusion of a low gear which is installed on an accelerator cable.
3. In interior of the car unscrew clips and remove the lower finishing of the panel from the driver for access to a pedal of management of fuel supply.
4. Remove a bracket of fastening and disconnect an accelerator cable from the top part of a pedal, management of fuel supply.
5. In a motor compartment take the ring condensing an accelerator cable from a partition and take an accelerator cable.

Installation

PERFORMANCE ORDER
1. From a motor compartment insert an accelerator cable into place and establish the condensing accelerator cable ring on a partition of a motor compartment.
2. Establish a cable cover in a pedal suspension bracket clamp, and connect a cable of an accelerator to a pedal of management of fuel supply.
3. In a motor compartment check that the cover of a cable of an accelerator is correctly placed in the condensing partition ring, then place a cable on all length in fastening brackets.
4. Connect an accelerator cable to a cam of a throttle and fix by a bracket. Establish a cable cover in an arm and adjust the provision of a cable of an accelerator.

Adjustment

PERFORMANCE ORDER
1. In a motor compartment remove a clip of fastening of a cover of a cable of an accelerator.
2. Check that the cam of a throttle was in the starting position and, moving a cable cover, choose sagging of a cable of an accelerator.
3. In the established provision of a cable establish a fastening clip on external flutes of a cover of a cable before the rubber condensing ring and a washer. After installation of a clip and a cable on the places only insignificant sagging of a cable of an accelerator has to be observed.
4. While the assistant smoothly presses an accelerator pedal, check that the throttle cam completely turns and comes back to a starting position.