Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
+ 3. Engines
- 4. Heating, ventilation
   + 4.1. Cooling system
   - 4.2. Heating system and ventilation
      4.2.1. Introduction
      - 4.2.2. Elements of system of heating Fan engine resistor Engine of the supercharger of a heater Control panel of a heater Heater casing Heater radiator Heater switch Vacuum tank Vacuum chamber Electronic control unit climate Electronic sensor of temperature Electronic regulator of the fan
   4.3. Air conditioning system
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

d65d3f49 Heater casing


1. Remove the dashboard.
2. Remove forward doors.
3. Unscrew bolts, the fixing external ends of a beam of management to forward racks. Then remove two top guides and unscrew bolts with the left carving since the ends of a beam.
4. Remove the lower distributor of air.
5. On models with the air conditioning system remove a cooler. The expert with use of the special equipment has to remove a cooler.
6. On models with air conditioning in a motor compartment disconnect hoses from the evaporator and remove drainage consolidation.
7. Working in a motor compartment, press the hoses giving cooling liquid to a heater radiator.
8. Disconnect hoses from the heater radiator union, pressing a branch pipe and moving a blocking ring.
9. Unscrew three bolts fixing a heater casing to a partition of a motor compartment. Bolts are available from a motor compartment.
10. Remove a pollen filter casing. For this purpose it is necessary to remove the engine of a screen wiper and to disconnect vacuum hoses from a casing. On models with diesel engines of 2,0 l it is also necessary to remove the sensor of temperature of external air.
11. On models with electronic control of air temperature disconnect the socket of a plait of wires for power supply of engines of the servomotor and the fan.
12. Take a heater casing from interior of the car.


Installation is made in the sequence, the return to removal.