|
|
Opel Vectra Bsince 1995 releaseRepair and operation of the car |
|
|
Vektr's Opel of B + 1.1. Governing bodies and control devices + 2. Maintenance + 3. Engines + 4. Heating, ventilation + 5. Fuel system + 6. Systems of start, ignition - 7. Transmission - 7.1. Coupling 7.1.1. Introduction 7.1.2. Technical characteristics 7.1.3. Removal of air from hydraulic system of coupling 7.1.4. Main cylinder 7.1.5. Working cylinder of coupling 7.1.6. Coupling pedal 7.1.7. Leading knot of coupling + 7.2. Mechanical transmission + 7.3. Automatic transmission + 7.4. Power shafts + 8. Brake system + 9. Running gear + 10. Body + 11. Electric equipment + 12. Main malfunctions 
|
7.1.3. Removal of air from hydraulic system of coupling
The screw of removal of air is screwed in in a hose which fastens on the top part of the transmission. On some models access to the screw is possible only from under the car. Unscrew a cover of a nutritious tank and check that the level of brake fluid in a tank was at the level of max tag. During removal of air you monitor availability of liquid in a tank, without allowing an exposure of its bottom as at the same time air will get to system again. Remove a dustproof cap from the union of pumping and put on it a pure transparent hose which other end needs to be lowered in the capacity which is partially filled with brake fluid. Sharply press a coupling pedal several times with an interval 2–3 sec. Unscrew on a turn floor the pumping union at the pressed pedal. Continuing to press a pedal, force out the liquid which is in system together with air through a hose in capacity. After the pedal will reach extreme forward situation, and replacement of liquid through a hose will stop, screw the pumping union to the full. Repeat these operations, the air outlet from a hose will not stop yet. Holding a pedal in the pressed situation, screw up the union against the stop and remove a hose. Wipe the union of pumping and establish a protective cap. |
|