Opel Vectra B

since 1995 release

Repair and operation of the car

Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   + 3.1. Repair of the SOCH engine installed in the car
   + 3.2. Repair of the DOCH engine installed in the car
   - 3.3. Repair of the diesel engine of 1,7 l installed in the car
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of pressure of compression
      3.3.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.3.5. Cover of a head of the block of cylinders
      3.3.6. Pulley of a bent shaft
      3.3.7. Casings of a gear belt
      3.3.8. Replacement of a gear belt
      3.3.9. Mechanism of a tension of a gear belt and pulleys
      3.3.10. Replacement of a sealing ring of a cam-shaft
      3.3.11. Check and adjustment of gaps of valves
      3.3.12. Cam-shaft and pushers
      3.3.13. Head of the block of cylinders
      3.3.14. Oil pallet
      3.3.15. Oil pump
      3.3.16. Oil heater
      3.3.17. Flywheel
      3.3.18. Replacement of sealing rings of a bent shaft
      3.3.19. Replacement of support of the power unit
   + 3.4. Repair of the diesel engine of 2,0 l installed in the car
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions

3.3.14. Oil pallet

Removal

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. Lift a forward part of the car and record on supports.

3. Merge engine oil from the engine. Establish a new washer on a masloslivny stopper and screw up a stopper in the oil pallet.

4. Unscrew bolts and remove the lower part of the oil pallet.

5. To remove a body of the oil pallet, remove a forward exhaust pipe.

6. Unscrew bolts and remove the lower protective plate of a flywheel.

7. Gradually unscrew bolts of fastening of a body of the oil pallet to a cover of the pump and block of cylinders of the engine. Take a body of the oil pallet from under the car.

8. Unscrew bolts and remove a maslopriyemny pipe with the mesh filter.

Installation

PERFORMANCE ORDER

1. Clear all traces of dirt and oil from the interfaced surfaces of the oil pallet and block of cylinders.
	2. Establish a new sealing ring on a pipe of an oil receiver and install an oil receiver pipe on the engine.
	3. Check that the interfaced surfaces of the main block of the oil pallet and the block of cylinders pure and dry and apply a thin film of sealant on the top part of the main oil pallet.
4. Install the main block of the oil pallet on the block of cylinders and fix by bolts. You make tightening of bolts from the center in the diagonal sequence.
5. Establish a protective plate of a flywheel.
6. Establish a forward exhaust pipe.
7. Check that the interfaced surfaces of the oil pallet and the lower oil pallet pure and dry. Apply a thin film of sealant on the interfaced surface of the lower oil pallet. Install the lower oil pallet and fix by bolts.
8. Lower the car and fill in engine oil in the engine.