Opel Vectra B

since 1995 release

Repair and operation of the car



Vektr's Opel of B
+ 1.1. Governing bodies and control devices
+ 2. Maintenance
- 3. Engines
   - 3.1. Repair of the SOCH engine installed in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. Top Dead Point (TDP) of the piston of the first cylinder
      3.1.5. Cover of a head of the block of cylinders
      3.1.6. Pulley of a bent shaft
      3.1.7. Casings of a gear belt
      3.1.8. Gear belt
      3.1.9. Mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. Cam-shaft and cases of a cam-shaft
      3.1.12. Hydraulic pushers
      3.1.13. Head of the block of cylinders
      3.1.14. Oil pallet
      3.1.15. Oil pump
      3.1.16. Drive flywheel / plate
      3.1.17. Replacement of sealing rings of a bent shaft
      3.1.18. Suspension bracket of the power unit
   + 3.2. Repair of the DOCH engine installed in the car
   + 3.3. Repair of the diesel engine of 1,7 l installed in the car
   + 3.4. Repair of the diesel engine of 2,0 l installed in the car
   + 3.5. Capital repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. Running gear
+ 10. Body
+ 11. Electric equipment
+ 12. Main malfunctions


d65d3f49

3.1.7. Casings of a gear belt

TOP CASING

Removal

PERFORMANCE ORDER
1. Remove a casing of the air filter.
2. Take off an auxiliary driving belt.
3. Unscrew screws of fastening (arrow) of the top casing of a gear belt and remove it from the engine.

Installation

Installation is made in the sequence, the return to removal.

LOWER CASING

Removal

PERFORMANCE ORDER
1. Remove a pulley of a bent shaft.
2. Remove the top casing of a gear belt, unscrew screws of fastening (arrow) and remove the lower casing of a gear belt.

Installation

Installation is made in the sequence, the return to removal.

BACK CASING

Removal

PERFORMANCE ORDER
1. Remove cogged pulleys from distributive and cranked shaft and the mechanism of a tension of a gear belt.
2. Unscrew bolts of fastening of a back casing and remove a casing.

Installation

Installation is made in the sequence, the return to removal.